Growth rendering device and Growth modeling device by David Bowen.
About the growth rendering device:
This system provides light and food in the form of hydroponic solution for the plant. The plant reacts to the device by growing. The device in-turn reacts to the plant by producing a rasterized inkjet drawing of the plant every twenty-four hours. After a new drawing is produced the system scrolls the roll of paper approximately four inches so a new drawing can be produced during the next cycle. This system is allowed to run indefinitely and the final outcome is not predetermined.
About the growth modeling device:
This system uses lasers to scan an onion plant from one of three angles. As the plant is scanned a fuse deposition modeler in real-time creates a plastic model based on the information collected. The device repeats this process every twenty-four hours scanning from a different angle. After a new model is produced the system advances a conveyor approximately 17 inches so the cycle can repeat. The result is a series of plastic models illustrating the growth of the plant from three different angles.
15 notes
-
mipiaccciono reblogged this from staceythinx
-
vulgarshudder reblogged this from staceythinx
-
llnd likes this
-
reversedfate likes this
-
rheadsine reblogged this from staceythinx
-
dontcallmeishmael likes this
-
biocas likes this
-
odizerdaspalavras likes this
-
dragondoeatpotato likes this
-
bentintoshape likes this
-
twicr likes this
-
d-e-r-r-i-c-k-a likes this
-
sweet--happiness likes this
-
king-owl reblogged this from staceythinx
-
ttaa likes this
-
mushroomsandwine reblogged this from staceythinx
-
staceythinx posted this
Visit the Thinx site